The Official OSDial Forum
Community run forum, for commercial support go to http://store.osdial.com
Hardware question
2 posts
• Page 1 of 1
Hardware question
by BlueAdept » Wed Feb 12, 2014 11:16 am
Does OSDial support fxo/fxs cards like the Sangoma A200E or does it only support T1 cards?
- BlueAdept
- Posts: 1
- Joined: Wed Feb 12, 2014 11:12 am
Re: Hardware question
by fadmin » Tue Feb 18, 2014 9:30 am
It supports all Sangoma cards.
Don't try to use analog phone lines (FXO) as it takes much too long to detect hangups.
Shut down the dialer, install the card and on boot it will detect it and load the driver.
You can always confirm the driver is loaded and card visible with 'lsmod' and 'lspci'.
Don't try to use analog phone lines (FXO) as it takes much too long to detect hangups.
Shut down the dialer, install the card and on boot it will detect it and load the driver.
You can always confirm the driver is loaded and card visible with 'lsmod' and 'lspci'.
- fadmin
- Site Admin
- Posts: 283
- Joined: Fri Feb 12, 2010 7:27 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests