SIP Registration String

For questions during install

SIP Registration String

Postby inv3nt0r » Tue Jun 01, 2010 7:09 am

I have just installed the dialer software, and entered the information for my SIP connection. The SIP line I am attempting to use is a single line which dials out of someone elses dialer. I can use X-Lite to make calls from this conection, and it requires authentication. Is there a configfuration file in which I must enter a 'registration string' in order to use this connection? Is it impossible to use this SIP line for testing purposes?

I noticed in VICIDIAL there is a setup page on the web interface to enter carrier information, on which the registration string can be entered. I suspect this can be accomplished by editing one of OSDial's .conf files.

Any help in this matter will be greatly appreciated. Thanks!

-- Grant Smith
Posts: 1
Joined: Tue Jun 01, 2010 6:56 am

Re: SIP Registration String

Postby sentm » Thu Jul 22, 2010 12:49 pm

Not at all.

You would just add the following to the /etc/asterisk/osdial_sip_registrations.conf file:

Code: Select all
register => user[:secret[:authuser]]@host[:port][/extension]

But I believe their next release will have GUI based carrier configuration.
Posts: 87
Joined: Wed May 26, 2010 10:53 pm
Location: Orlando, FL

Return to Installation

Who is online

Users browsing this forum: No registered users and 1 guest